Chapter 4: Reports
P/N 3102351-EN • REV 005 • ISS 28DEC18 167
System Status report
The panel provides a System Status report for all active points in the system. The report can
include: all active points, all alarm points, all supervisory points, all trouble points, all disabled
points, or all other points. System status reports can be printed or viewed on the LCD.
To view a System Status report:
1. Press the Menu button and choose Reports.
2. Choose System Status.
3. Choose one of the following:
All
Alarm
Supervisory
Trouble
Disable
Other
Correlation Groups report
The panel provides a report for each correlation group in the system. The Correlation Group
report shows all of the devices, zones, and NACs that are assigned to a correlation group.
Correlation group reports can be printed or viewed on the LCD.
To view a Correlation Groups report:
1. Press the Menu button and choose Reports.
2. Choose Correlation Groups.
3. Enter the number of the correlation group for which you want a report.
Correlation Group Configuration report
The Correlation Group Configuration report lists:
• All correlation groups with in-suite signal silence enabled.
— or —
• All correlation groups with an activation count greater than 1. This provides information on
correlation groups programmed for special applications.
• The Delay report displays a list of correlation groups from which the Reset is configured as
Function Activate or Restore.
To Next Page
Loading...
