PMC-A 7
Grounding
• This product is an IEC Safety Class I equipment (equipment
with a protective conductor terminal). To prevent the
possibility of electric shock, be sure to connect the protective
conductor terminal of the product to electrical ground (safety
ground).
Installation
• This product is designed for safe indoor use. Be sure to use
it indoors.
• When installing this product, be sure to observe the
description in 2.2 Precautions Concerning Installation
Location in this manual.
Relocation
•Turn off the POWER switch, and disconnect all cables
before relocating the product.
• When relocating the product, be sure to include the manual.
Operation
•If a malfunction or abnormality is detected on the product,
stop using it immediately, and remove the power plug from
the outlet. Make sure the product is not used until it is
completely repaired.
• Use cables or wires with sufficiently large current capacity
for output wires and load cables.
• Do not disassemble or modify the product. If you need to
modify the product, contact your Kikusui distributor/agent.
Maintenance
and
inspection
• To prevent the possibility of electric shock, make sure to
unplug the power plug before carrying out maintenance or
inspection. Do not remove the external cover during
maintenance or inspection.
• Check that the insulation coating of the power cord is not
broken and that the plug is not cracked or falling apart.
• If the panel needs cleaning, gently wipe using a soft cloth
with water-diluted neutral detergent.
• To maintain the performance and safe operation of the
product, it is recommended that periodic maintenance,
inspection, cleaning, and calibration be performed.
Service
•Kikusui service engineers will perform internal service on the
product. If the product needs adjustment or repairs, contact
your Kikusui distributor/agent.
G
N
L
To Next Page
Loading...
