Kikusui TOS5050A - Page 99

TOS5051A/5050A 7-9
Chap.7
RS-232C Interface
TMODE? (TMOD?)
Queries the test mode setting.
Response
Returns any of the following:
TMODE0, TMODE1, TMODE2, or TMODE3
REMOTE
Enables the START command through the RS-232C.(RS-232C REMOTE mode)
The “REMOTE” message on the panel lights.
Response
Returns OK.
• The tester returns to LOCAL mode when the tester is power cycled.
LOCAL
Disables the START command through the RS-232C.(RS-232C LOCAL mode)
The “REMOTE” message on the panel turns OFF.
Response
Returns OK.
START
Starts the test.
Response
• When the START command is enabled (RS-232C REMOTE mode)
Returns OK.
• When the START command is disabled (RS-232C LOCAL mode)
Returns ERROR.
• The START command is valid when the tester is in the RS-232C REMOTE mode
(REMOTE command already issued).
NOTE
NOTE