Kinetec CEM - PROGRAM MODE: Entering Programs on KINETEC CEM

KINETEC CEM™ 12/22 EN
USING THE HAND CONTROL
11. PROGRAM MODE: To enter a program
Beginning
Keys to
press
Display Remarks
To switch off the unit
Press the 2 keys at the same time and
switch the unit ON
KINETEC
ELBOW MODULE 0.6
Welcome text displayed for 3
seconds
Then
PROGRAM Nr2
EMPTY
The program number blinks.
To change the program if necessary
or
PROGRAM Nr10
EMPTY
The new program number blinks.
To choose the treatment mode
PROGRAM Nr10
10 EXT/FLEX 90
The display indicates the selected
treatment mode, the program
number blinks again.
Or
PROGRAM Nr10
10 WARM UP 90
To display the extension or flexion limit of
the movement
PROGRAM Nr10
10 EXT/FLEX 90
The value blinks.
Or
PROGRAM Nr10
20 EXT/FLEX 120
To change the limit if necessary
or
PROGRAM Nr10
20 EXT/FLEX 120
The new value blinks.
To confirm the new value, press another
key
or wait more than 3 seconds
PROGRAM Nr10
SPEED: 1
While the value blinks press
or
to change if necessary.
PROGRAM Nr10
FORCE: _ _ _ _ _
PROGRAM Nr10
TIMER 00H00MIN
PROGRAM Nr10
PAUSE LOW 0s
To record program 10
PROGRAM Nr10
SAVE:+ CLEAR:-
Then
PROGRAM Nr10
SAVING
Program 10 has been recorded and
the display indicates the next
program so you can change
another program.
OR
To cancel the program
PROGRAM Nr10
CLEARING
Program 10 has been removed and
the display indicates the next
program so you can change
another program.
To exit program mode, switch the unit OFF
and switch back ON.
KINETEC
ELBOW MODULE 0.6
To use the modified program see
page 14.
Comments:
• The values in the display column are given as an example.