Kinetec CEM - Using the KINETEC CEM Hand Control; KINETEC CEM Electrical Connection and Safety; Starting the KINETEC CEM Unit

KINETEC CEM™ 8/22 EN
1
2
3
USING THE HAND CONTROL
1. Electrical connection: safety first
2 versions of electrical protection are available for KINETEC CEM™ machines.
The identification label shows which version a machine is equipped with:
Type BF, Class II devices,
for home use, bear the following symbols:
Type B class I devices,
for use in a professional environment, bear the following symbol:
See page 20 for the meaning of the symbols.
Before connecting the device to the power supply, check that the mains voltage
matches that shown on the plate (100-240 V~ 50/60Hz).
The connectors can be plugged in any one of the sockets
(the sockets are not assigned to a specific connector).
Connect the power supply cable (1).
IMPORTANT
For Type B Class I devices, and to avoid all risks of electric shock, the
machine should only be connected to a power supply that has protective
earthing.
To connect the power supply, only use the original cable supplied with the machine.
Check that the cables remain free around the device so that they do not get damaged.
Check that the machine is not damaged, in particular the protective housings.
Watch out for the position of the motor cables. They must remain clear around the machine.
Wrong position Correct position
2. Starting the unit
Press the ON / OFF switch (2). The indicator light (3) lights up, the machine carries out an auto-diagnostic, and then the
display shows:
KINETEC
ELBOW MODULE
Then
Movement Verif.
Please Wait
Then
ELBOW MODULE
30 STOP 15 70
Your device KINETEC CEM™ is ready to be used with the parameters from the previous session
(except Timer and Warm Up mode)
Warning: Always check the motion parameters displayed on the hand control before starting the session.