Kinetec CEM - KINETEC CEM Basic Assembly; Assembling KINETEC CEM Kit Components

KINETEC CEM™ 5/22 EN
1
2
4
4
3
5
DESCRIPTION
9. Basic assembly
- Place the chair (1) on the floor; we recommend that two people carry out this operation.
Take care not to trap your fingers.
- Straighten up the back of the chair (2).
The tilting axis (3) must always be in good condition. Never use the device without it.
- Lock the back of the chair by tightening the red knobs (4).
- Install the abduction motor (5) on the right or left, depending on
the limb be moved.
WARNING: Before each use, always check that the red knobs
under the chair have been tightened (see page 5).
WARNING: Before each use, always check that the various
locking knobs have been tightened (see pages 6
and 7).
Comments and special instructions:
Take care that fingers do not get pinched during handling operations or
when the chair is unfolded.
Never carry the device by the chair when it is in its working position.
10. Assembling the components of the KINETEC CEM™ Kit
Install the elbow motor support (3) Install the elbow motor (2) Install the forearm splint (6).
using the colour code as guide using the colour code as guide. It is correctly installed when you hear a click.
(Blue for left, Red for right). It is correctly installed when you hear a click.
It is correctly installed when you hear a click.
Install the arm splint (5). Install the elbow protection (4). The device KINETEC CEM™ is shown ready
It is correctly installed when you hear a click. for a right shoulder mobilisation.
3
2
6
5
4