EasyManuals Logo

Kinetico K5 Manual

Kinetico K5
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
K5 Drinking Water Station
Revised: 09/2016 Drinking Water Systems Section 7
Page 37
11. Wait 4 Minutes.
12. Close feed.
13. Close tank valve.
Note: You may hear a buzzing sound from
the unit. This is normal for start-up.
14. Slowly open faucet to depressurize the system.
15. Leave faucet open.
WARNING:
Do not open faucet all the way. Air, water and
chemical solution will spray out forcefully. Be
prepared to control the anti-spray line.
16. Remove sanitization cartridge.
17. Add 5 mL unscented bleach to a
sanitization cartridge that is half full of
clean water.
WARNING: Handle cartridge
with care when removing May
contain chemical solution.
Install in prefilter position.
18. Install RO
19. Remove ⅜” plug from yellow port on manifold and insert
⅜” tube into same port. Place other end into a 5 gallon
bucket.
Remove ⅜” plug from yellow port

Other manuals for Kinetico K5

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kinetico K5 and is the answer not in the manual?

Kinetico K5 Specifications

General IconGeneral
Filter TypeReverse Osmosis
Daily Production Rate50 gallons per day
CertificationsNSF/ANSI 58
Filter Life6-12 months
Waste Water Ratio1:1

Related product manuals