K5 Drinking Water Station
Section 7 Drinking Water Systems Revised: 09/2016
Page 38
20. Turn jack screw completely.
21. Slowly open feed valve.
22. Fill Bucket. Hold onto line
while bucket fills.
Warning: Do not overflow.
24. Turn jack screw completely
(clockwise).
25. Remove ⅜” line and replace
plug in yellow port.
Note: Do not over tighten.
26. Discard water in bucket.
27. Open tank ball valve.
28. Wait for flow to drop off.
Close feed and allow system to depressurize.
Leave faucet open.
29. Remove prefilter
sanitization cartridge and
cartridge plugs (as
necessary).
32. Wait for steady permeate
flow at the faucet, then
close the faucet. Remove
anti-spray line.
30. Install all remaining
cartridges.(Cartridges
must be prepped
according to their
installation instructions).
Use cartridge plug for any
unused auxiliary port.
33. Inform customer to
discard first two tanks
of water.
To Next Page
Loading...
Need help?
General
