Chapter 1 Before Use 1-6
1. 4. 2 Printer part
Subject Specification
Printing method LED Array Electro photography
Photoreceptor Organic Photoconductive Drum
Print speed 80mm per second
(Inch) 3.4ppm/E 5.8ppm/D Landscape
(Metric) 3.3ppm/A0 5.6ppm/A1 Landscape
Print head LED Array
Resolution of print head 600dpi x 600dpi
Print width Maximum 36” or 914mm
Minimum 11” or 297mm (roll media)
8.5” or 210mm (cut sheet)
Print length Maximum
(Standard) 19.7ft (6,000mm) for 36” / A0 wide (plain paper)
or “5 x Standard length” (plain paper)
“2 x Standard length” (tracing paper)
“1 x Standard length” (film)
(Option) 75ft (24,000mm)
Minimum 8.5” or 210mm
Warm up time Shorter than 4 minutes 30 seconds
(At 23
o
C, 60%RH, the rated voltage, and plain paper is used)
First print time 18 seconds (D Landscape)
(At 23
o
C, 60%RH, the rated voltage, and plain paper is used)
Fusing method Heat and Pressure Rollers
Development method Dry type non-magnetic mono-component toner
Media (Recommended Media)
US model:
Bond Paper 64g/m
2
to 80g/m
2
, US Bond (PB-20)
Vellum US Vellum (XV-20)
Film 4MIL (PF-4DDME)
Europe/Asia model:
Plain Paper 64g/m
2
to 80g/m
2
, Oce Red Label (75g/m
2
)
Tracing Paper Oce Transparent Paper (80g/m
2
)
Film Oce 3.5MIL
Storage of consumables (Toner cartridge)
Store the cartridge within the temperature range from 0 to
35 degrees Centigrade and within the humidity range from 35
to 85% RH.
NOTE
The above specifications are subject to change without notice.
NOTE
If the print is longer than 6,000mm, its image quality or the
reliability of paper feeding is not guaranteed.
To Next Page
Loading...
