KIP 770K - Printer Part

Chapter 1 Before Use 1-6
1. 4. 2 Printer part
Subject Specification
Printing method LED Array Electro photography
Photoreceptor Organic Photoconductive Drum
Print speed 40mm per second
(Inch) 1.7ppm/E 2.9ppm/D Landscape
(Metric) 1.6ppm/A0 2.8ppm/A1 Landscape
Print head LED Array
Resolution of print head 600dpi x 1800dpi
Print width Maximum 914mm / 36”
Minimum 297mm / 11” for roll media
210mm / 8.5” for cut sheet
Print length Maximum
(Standard) 2,400mm for A0 / 36” wide
(plain paper / bond)
or “2 x Standard length”
(plain paper / bond)
“1 x Standard length”
(plain paper / bond, 2” core roll)*
“1 x Standard length”
(vellum / tracing paper, film)
(Option) 3,600mm
Minimum 297mm / 11”
Print size
(from Paper Tray, option)
ISO (mm)
Width
Length
ANSI (inch)
Width
Length
Warm up time Shorter than 2 minutes 30 seconds
At 23
o
C, 60%RH, the rated voltage, plain paper
First print time 42 seconds (D Landscape), 41 seconds (A1 Landscape)
At 23
o
C, 60%RH, the rated voltage, plain paper
(after submission of the concerning plot data)
Fusing method Heat and Pressure Rollers
Development method Dry type non-magnetic mono-component toner
NOTE
If the print is longer than 2,400mm, its image quality or the
reliability of paper feeding is not guaranteed.
420 297 210
594 X
420 X
297 X X
18 17 12 11 9 8.5
24 X
22 X
18 X
17 X
12 X X
11 X X