Chapter 2 Basic Operation 2-14
2. 6 Cut Sheet Media
There are several size markings on the table of Bypass Feeder which indicate possible feed
positions.
Place the cut sheet on the table between its concerning size markings then insert it into the Bypass
Feeder. When the leading edge touches the feeding roller, the printer automatically carries and
sets the paper at the proper position.
NOTE
(1) As a curly cut sheet will cause a mis-feed, straighten the sheet as far as possible before
printing. And set the sheet in “curl down” direction as a mis-feed can be avoided. “Curl up”
sheets tend to result in a mis-feed.
Correct: curl down Wrong: curl up
(2) Setting a cut sheet to the Bypass Feeder while the printer is processing a print job cause a
paper jam.
size marking
To Next Page
Loading...
