DP485 Service Manual
18
center will not receive any alarm signal.
2) Regular —— The radio sends emergency alarm and audio-video alert.
3) Silent —— The radio sends emergency alarm but no audio-video alert. When the radio receives speech
signals, the speaker will not be turned on until the PTT button is pressed.
4) Silent with voice —— The radio sends emergency alarm without audio-video alert. When the radio
receives speech signals, there will be no audio-video alert until the PTT button is pressed.
Alarm Modes
1) Alarm: The radio sends an emergency alarm and then quits alarm mode.
2) Alarm with call: The radio sends an emergency alarm can initiates an emergency call by holding down
the PTT key.
3) Alarm with voice to follow: The radio sends an emergency alarm and then sends background tone
periodically.
Note:
An emergency alarm is non-speech signals sent from a radio in a group to other radios in the group, so
that alarm prompt will be given off on these radios.
To guarantee communication under emergency, an alarm call has a higher call priority than a common call
does.
5.7.Settings
The radio has been set before delivery. However, to meet customers’ requirements, it may be necessary to
set such digital functions as operating frequencies, channels, DT/DQT and automatic scan. This can be
achieved by the programming software CPSM Vx.xx developed by Kirisun. It is user-friendly and easy to
operate, and supports Chinese and English.
To set the parameters of the radio using the software, take the following steps.
Step 1.Install the CPS software on your PC.
Step 2.Connect the radio to the PC using the programming cable.
Note:
Make sure the radio is powered on.
Step 3.While connecting the programming cable for the first time, please install its driver.
Step 4.Run the CPS software Kirisun CPSm_VX.XX.
Step 5.Click Setting → Communication Port, and select the serial port to which the programming cable is
connected.
Step 6.In the software, select Program → Read Data. In the prompted dialog box, click Read. The radio
To Next Page
Loading...
