EasyManuals Logo

KIRLOSKAR KC Series User Manual

KIRLOSKAR KC Series
58 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
IMPORTANT
CHECKS :
BEFORE STARTING THE COMPRESSOR
1 Tightness & correct fitment of flywheel on crankshaft (tightening torque : 35 Kg. m)
2 Proper alignment of compressor-flywheel & motor-pulley.
3 3/4 of Sight glass level of refrigeration oil in compressor.
4 Correct connections of compressor safety cutouts (HP, LP, OP)
5 Mounting of gauges on separate panel (not on compressor)
PRIMING: Pour oil into shaft seal cover (1 litre).Fill oil in Suction /Discharge oil filter housings.
BEFORE OPERATING / MOUNTING TAL STOP VALVES: Apply oil & grease in glands to prevent
gland leakages.
AIR RUN TRIAL : Run the compressor on air for five minutes with suction & discharge ports of
2
compressor open & check oil pressure, (Minimum 1.5 Kg/cm g). Check loading & unloading of
compressor by operating capacity control solenoid valve (CCSV) one at a time.
SINGLE STAGE COMPRESSOR (KC2, KC3, KC4, KC6, KC9, KC12) : Do not start compressor
on 100% load. Load compressor by operating CCSV. as per the temperature/load requirement.
Before stopping unload all CCSVs.
TWO STAGE COMPRESSOR (KC2.1, KC3.1, KC4.2, KC5.1, KC6.3, KC7.2, KC8.4, KC9.3,
KC10.2) : Run the compressor on direct cylinder to achieve room temperature minus 10° C & then
load CCSV.
2
WARNING : Intermediate pressure should not go above 4 Kg/cm g as this will cause high
pressure/high discharge temp. (above 100°C) & may damage compressor (refer manual) - page
19, 5.4.
MAINTENANCE (COMPULSORY) : After commissioning change/check oil, oil filters and gas-
strainer after initial 4,8,50 & 100 hrs of running of compressor. This should be continued till oil in the
crankcase sump remains clear. Always maintain a log book & install an hour meter.
Before commissioning of compressor, please write to ACR SERVICE DEPARTMENT at
'KIRLOSKAR PNEUMATIC CO. LTD' , HADAPSAR INDUSTRIAL ESTATE, PUNE - 411 013.
Phone: 020-26870133/26870341 giving following details 30 DAYS IN ADVANCE to register your
name in our data list to enable us to provide you prompt service.
1) Name plate data; 2) Motor name plate data; 3) Postal address where compressor is installed
AND 4) Compressor application details.
Only after receiving above details, end user will be sent WARRANTY CARDS, Writeups & other
information/data, etc.
1 ) READ THE MANUAL CAREFULLY.
2) DISPLAY THE MAINTENCE SCHEDULE SENT WITH COMPRESSOR IN PLANT ROOM &
FOLLOW IT STRICTLY.
3) INFORM NEAREST KPCL BRANCH OFFICE/DEALER ABOUT COMMISSIONING OF THE
COMPRESSOR.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KIRLOSKAR KC Series and is the answer not in the manual?

KIRLOSKAR KC Series Specifications

General IconGeneral
BrandKIRLOSKAR
ModelKC Series
CategoryAir Compressor
LanguageEnglish

Related product manuals