11 .13 CAPACITY CONTROL OIL PIPING
Sr. Name of the Part
No.
1 Union Socket screw Assly. 998.16.243.50 For 6 mm tubing
1.1 Union socket Screw 999.16.243.50
1.2 Union Nut 999.16.001.50
1.3 Ferrule 999.16001.50
2 T connecting socket assly. 998.16.543.50 For 6 mm tubing
2.1 T connecting socket 999.16.541.50
2.2 Union Nut 999.16.063.50
2.3 Ferrule 999.16.001 .50
3 Packing 999.18.525.50
4 Solenoid Valve Assly. 082.25.030.50 For 230 V.A.C.
4.1 Coil for Solenoid valve 082.25.032.50 230 V A.C.
5 K-5 Valve Assly. 082.16.00150 For 6 mm tubing
5.1 '0' Ring 999.12.626.50
6 Steel Tube 6 dia 999.37.103.00
7 Adaptor (Top) Solenoid Valves 082.25.011.50 For 6 mm tubing.
(Above mentioned parts are normally required to fabricate the capacity control
piping at site. Quantity will depend upon type of compressor.
Part No. Remark
11.14 SPECIAL TOOL KIT FOR ASSEMBLY
Drawing No. - 082.24.025.50 (Fig No. 43)
Sr. Name of the Part Part No. Qty. Remark
No.
1 Bottom Plate 082.24.042.50 1
2 Stud 082.24.043.50 1
3 Hex Nut M 16 999.06.687.50 1
4 Top Plate Assembly 082.24.041.50 1
5 Hex Hd Screw M20x125 L 999.01.760.50 1
6 Bush for Piston insertion 082.24.020.50 1
7 Key for Piston Removal 082.24.030.50 1
Figure 43
UNSCREW THE BOLT
TIGHTEN THE BOLT
(TO BE PRESSED INSIDE)
PISTON
ASSEMBLY
PULL THE KEY UP
CYLINDER LINER REMOVAL FIXING CYLINDER LINER
PISTON ASSEMBLY INSERTION PISTON ASSEMBLY REMOVAL
CRANK CASE
CYL. BLOCK
CYLINDER
LINER
2
1
3
4
5
1
7
6
42