18
This chapter for Chain Hoist includes important contents to prevent injury to persons performing inspection, users and
other persons and damage to property, and to disassemble/reassemble the Chain Hoist safely and correctly.
Before performing the inspection, be sure to read and follow page 5 to 16 since its contents are also important for
inspection.
Disassembly/reassembly of Chain Hoist is essential for inspection. Refer to the separate Disassembly/reassembly
Manual to perform inspection correctly.
Safety precautions
Person to perform inspection
Inspection shall be performed only by a competent person*
* Person who is authorized by company to have expertise on the structure and device of Chain Hoist, or has
expertise and is capable of understanding page 17 to 31 and Disassembly/reassembly Manual.
When this requirement is not satisfied, consult with KITO, or request KITO for inspection.
Inspection in general
Only competent persons to perform inspection of the Chain Hoist.
Inspection performed by anyone other than a competent person may result in death or severe injury.
Do not use parts beyond their discard limit or criteria and unauthorized parts for KITO
Chain Hoist Model CX003/005.
Even though the part is an authorized part for KITO Chain Hoist, it may not be used for a different model.
Use parts correctly in accordance with the Disassembly/reassembly Manual.
Failure to do so may result in death or severe injury.
Do not perform inspection of Chain Hoist subject to a load.
When performing inspection of a Chain Hoist, place it on a floor and perform the inspection.
Performing inspection of a Chain Hoist subject to a load may result in death or severe injury.
Do not lubricate the Friction Plate.
The Friction Plate is of the dry type.
Lubricating the Friction Plate may result in death or severe injury due to insufficient braking.
Do not use any oil (grease, rust preventive oil, etc.) in areas near a fire or spark.
Otherwise, this may result in ignition.
Prohibited
Prohibited
Prohibited
Prohibited
Mandatory