3
Before disassembly and reassembly
Safety precaution Before disassembly and reassembly
Mandatory
Mandatory
Mandatory
• Only competent persons with expertise and experience must disassemble/reassemble the electric chain hoist.
Alternately, contact the nearest distributor or KITO.
Disassembling/reassembling improperly causes death or severe injury.
• Perform disassembly and reassembly in correct procedures as described in the manual.
• Do not extend the load chain.
• Before reassembling the parts such as gear, clean and remove oil and dust on them.
Especially when a plastic hammer is used, clean them thoroughly so that no chip of the hammer
remains inside.
• Prepare anti-loosening (screw lock) for bolts. Apply it to the specified locations.
• Use only authorized parts for replacement.
Failure to follow these instructions may result in death or severe injury.
• When reassembling, follow the instructions below.
• Before reassembly, remove dust and oil on the part to be reused.
• Insert snap rings completely in the groove.
• Assemble the load chain without torsion.
• When setting the plate in the gear case, be careful so that your finger won't get caught.
Failure to follow these instructions may cause bodily injury or loss of property arising from damaged
product or dropped parts.
• When reassembling, replace the following parts with new ones.
• Gear oil (type and required amount of oil vary depending on the specification and main body size.
Refer to page 48.)
• Packing
• Molybdenum disulfide lubricant Molytherm No.2: (specified brand: SUMICO LUBRICANT)
• Oil seal
• Snap ring
• Split pin
• O ring
Failure to follow this instruction may cause bodily injury or loss of property.
The disassembly and reassembly procedures are described based on the representative model. Note that
components may be slightly different for different capacities.
The specifications may be changed without prior notice and may be different from the actual products.
Note
Danger
Caution
To Next Page
Loading...
Need help?
General
