KITO ER2 Series Disassembly And Reassembly Guide

2
 Disassembly and reassembly (general)
Safety precautionDisassembly and reassembly (general)
Safety precaution
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited
Mandatory
Mandatory
• Do not use gear oil or grease in areas near a fire or spark.
Failure to follow this instruction may result in fire or severe injury arising from ignition.
• Carry out the installation or removal work after securing the stable foothold.
Failure to follow this instruction may result in death or severe injury due to falling or dropping.
• Do not cut, extend, or weld the load chain.
Failure to follow this instruction may result in death or severe injury.
• Carry out the installation or removal work of the electric chain hoist after shutting down the power distribution
panel.
Failure to follow this instruction may result in death or severe injury due to an electric shock.
• When reassembly is complete, perform a function check (preoperational check) to make sure it operates properly.
Failure to follow this instruction may result in death or severe injury.
For details, refer to 'Periodic Inspection' in the separated Owner's Manual.
• Tighten the bolts and nuts with the specified tightening torques.
Failure to follow this instruction may result in death or severe injury.
• Only competent persons must disassemble/reassemble the electric chain hoist.
Disassembly/reassembly by anyone other than competent persons may result in death or sever injury.
• Do not use unauthorized parts for KITO Electric Chain Hoist.
Even if the part is an authorized part, it may not be used for a different model.
Use parts correctly in accordance with this manual.
Failure to follow this instruction may result in death or severe injury.
• Do not perform disassembly/reassembly during conduction.
Failure to follow this instruction may result in death or severe injury due to an electric shock or
unexpected operation.
• Do not adjust or disassemble the friction clutch and friction clutch with mechanical brake.
Failure to follow this instruction may result in death or severe injury.
If adjustment and disassembly are required, contact Kito.
Prohibited
• Do not disassemble/reassemble the Electric Chain Hoist subject to a load.
When disassembling/reassembling an electric chain hoist, place it on a floor and perform them on the
workbench.
Failure to follow this instruction may result in death or severe injury.
Danger
Mandatory
Mandatory

KITO ER2 Series Specifications

General

Control Voltage	24V
Duty Cycle	40% ED
Protection Class	IP55
Temperature Range	-20°C to +40°C
Type	Electric Chain Hoist
Frequency	50/60 Hz
Motor Insulation	Class F
Brake Type	Electromagnetic
Load Chain Grade	Grade 80
Ambient Temperature	-20°C to +40°C
Power Supply	3-phase
Lift Height	3 to 30 meters
Chain Falls	1 or 2
Voltage	200-240V, 380-480V