11
2.2 CONDITIONS FOR OPERATION
INTENDED USE
The machine is designed to move people to overhead posions in order to perform operaons from inside the work plaorm.
Use of the machine is permied if the instrucons shown in this manual are complied with.
Any other use than that specied, or not included or inferable from this manual, should be considered mishandling and
therefore is not permied.
UNAUTHORISED USE
Any uses not outlined by regulaon UNI EN 280 fall under the direct responsibility of the user, who is required to comply with
the legal provisions in force regarding health and safety in the workplace.
NOTE!! The machine cannot be put back into use aer undergoing structural alteraons or addions of other components
which do not come under roune and special maintenance unless a new declaraon of conformity is issued.
TEMPERATURE
The machine operates properly in the following environmental condions:
- Minimum temperature: - 10°C
- Maximum temperature: + 40°C
- Humidity: 80% at 40°C
If used in a cold climate, start the machine and allow the oil, equipment, and systems to warm up.
Upon rst use, take special care during manoeuvres.
Constantly check that the baeries are charged.
Minimum starng temperature: - 20°C
For use in condions other than those specied above, always contact the manufacturer.
Use of the machine in any other installaon condions than the original conguraon supplied by the
manufacturer is prohibited, as is use of the machine in any way other than that stated herein.
Use is prohibited in the event of funconal anomalies and non-compliances with the use and safety
requirements stated in this manual. In the event, request and wait for the authorised personnel.