Novar 1xxx KMB systems
14
Exception: In the Manual mode the parameter values cannot be viewed. Instantaneous output values
are displayed on pressing button P (parameters) — see description further below.
1.9.2 Novar 10xx Controllers
Novar1005, 1007, 1005D and 1007D controllers are equipped with 3 buttons only – instead M- and P-
buttons, they features one ►- button.
Listing through windows is analogic; the only difference is that both instantaneous measured values
and controller parameters are situated in one common main branch, one below another ( see Fig.1.4 ).
Fig. 1.4 : Instantaneous values and parameters (Novar 1005 / 1007)
1.9.3 Test and Error Messages
In the instantaneous value display mode a test or error message pops up in place of an instantaneous
power factor value in some situations. Each message is described further below in more detail. In
these situations, if the value shown does not represent instantaneous power factor, the COS LED
flashes.
1.10 Indication LEDs
Besides the numeric display and adjacent LEDs, COS , A , V, the front panel has some more
indication LEDs.
To Next Page
