Novar 1xxx KMB systems
25
If the automatic section power recognition process can not be completed successfully or none of the
sections recognized is capacitive, flashing C=0
C=0 C=0
C=0 is shown on the numeric display and the Alarm
signal is activated at the same time. In such an event, it is necessary to enter each section’s value
manually (see description further below) or by editing parameter 20 enter value 1
1 1
1 (= carry out the
automatic section recognition power process) and thus force another start of the automatic section
power recognition process. Then do not forget to set the value back to A
AA
A !!!
The automatic section power recognition process can be stopped any time by switching the display
mode to Parameters. On return to the instantaneous value display mode the automatic section power
recognition process will be started over again.
To Next Page
Loading...
