Kodak ESP 7 Printer User Guide 21
Use this chapter to set up and start using your Kodak All-in-One printer.
Selecting a printer location
Place your printer on a clean, flat surface in a dry, well-ventilated location, away from
direct sunlight. Avoid areas with high levels of dust and debris. Do not expose the printer
and paper to ventilation ducts, open doors, or high traffic, as airborne particles can affect
picture quality.
Allow enough space on all sides of the printer to comfortably connect and disconnect
cables, change ink cartridges, and remove or load paper.
To ensure getting good signals from your networked computer(s), minimize obstacles
between the network router and the printer (and other wireless devices, such as
Bluetooth–enabled camera phones, etc.). The printer will function best with as clear a “line
of sight” as possible between it and the router.
In addition, keep the printer away from microwaves, and away from 2.4 GHz wireless
telephone handsets.
Configuring printer settings
Printer settings can be adjusted in two ways: via the control panel or the Home Center
software that comes with your printer (see Home Center Help for more details).
Configuring basic settings
1 From the control panel, press Menu.
2 Press
until Printer Settings is selected, and then press OK.
3 Press
until the parameter you want to configure is selected, and then press OK. To
review the available options and settings, see “Printer settings options” on page 22.
4 Press
or to configure the Date and Time, Tagged Image Printing, Control Panel
Settings
, Language, or Reset All Settings.
3
Setting Up Your Printer
To Next Page
Loading...
