Chapter 8
Kodak ESP 7 Printer User Guide 65
8 Press down on the tab until you hear a click and feel the latch snap into position.
9 Close the printer access door. The printhead moves to its ready position and prepares
the new ink cartridge for use (this could take up to a minute).
Replacing the printhead
If your printhead is damaged or broken, you may replace it yourself.
1 Make sure your printer is turned on.
2 Open the printer access door by lifting from the recessed hand-holds on the sides of the
unit.
Note: Listen carefully during this step; make sure you hear the ink cartridges click
into place in the printhead. This seats the cartridges properly, and prevents ink from
being dispensed incompletely during your print or copy jobs.
To Next Page
Loading...
Need help?
General
