Kodak ESP 7 ALL-IN-ONE PRINTER - Loading Originals for Copying;Scanning

Chapter 3
Kodak ESP 7 Printer User Guide 31
For Macintosh
To install the printer on another computer in your network, use the following steps:
1 Install the Kodak software that came with your printer on the target computer.
2 Click
System Preferences.
3 Click
Print & Fax.
4 Click the + sign to add the printer.
5 Select the Kodak ESP 7printer from the list of available printer(s).
The printer will be named Kodak ESP 7-XXXXwhere XXXX is a number unique to your
printer.
Switching the printer connection type
You can change the way you connect to your All-in-One printer at anytime.
For Windows
USB to Wi-Fi
To convert the USB connection from a PC to a wireless network connection:
1 Disconnect the printer from the computer.
2 Use the Windows Control Panel to delete the printer from you computer.
3 Configure the wireless network from the printer front panel. See “Configuring a wireless
network connection” on page 24.
4 Press
Menu.
5 Press until Network Settings menu is selected, and then press OK.
6 Select
View Network Configuration and confirm you have an IP address.
7 Run the Kodak Printer Network Setup Utility. This is located on the
Start > All
Programs
> Kodak >Kodak Printer Network Setup Utility. If Macintosh, this
procedure is not necessary.
8 Select
Connect via Network - Wireless / Wi-Fi then click Next to proceed. The printer
should be detected and driver installations begin. If you have more than one printer
connected to your network, select the printer then click
Next.
9 After the driver installation completes, click Done to proceed.
10 The printer will be named Kodak ESP7-XXXX where XXXX is a number unique to your
printer.