Chapter 9
Kodak ESP 7 Printer User Guide 89
Probable Cause 5
A Virtual Private Network (VPN) is preventing the printer from accessing your computer.
Corrective Action
Try temporarily disabling the VPN before proceeding with the installation.
Probable Cause 6
The Ethernet cable is not plugged in to the router, switch, or hub. The cable may also be
defective.
Corrective Action
Try reinserting the cables. Or, if necessary, try a different cable.
Probable Cause 7
The All-in-One printer is assigned an AutoIP address instead of DHCP.
Corrective Action
This indicates that the printer is not connected properly to the network. Check the
following:
• Make sure all cables are connected properly and securely.
• If the cables are connected properly, your access point, router, or home gateway might
not be sending an address. If this is the case, you might need to reset the device.
• Make sure the All-in-One printer is on the correct network.
• Restart your All-in-One printer.
Probable Cause 8
The printer is on the wrong Subnet or gateway.
Corrective Action
Print a network configuration page, and verify that the router and printer are on the same
subnet and gateway.
To print the network configuration page
1 On the control panel of the printer, press
Menu.
2 Press
until Network Settings is highlighted, and then press OK.
3 Press
until Print Network Configuration is highlighted, and then press OK.
Note: The All-in-One printer functionality will be limited during VPN sessions.
To Next Page
Loading...
Need help?
General
