A-61670 August 2014 2-5
Turning the scanner
on
1. Press the main power switch on the back of the scanner to the On (I)
position. The LED on the front of the scanner will be a steady yellow and
nothing will be displayed on the Operator Control Panel (this is low power
mode).
NOTE: If there is paper in the input elevator, the scanner will
automatically go to the Ready mode.
NOTES:
• It is not necessary to turn the main power switch off unless you are not
going to use the scanner for a prolonged period of time, you are
performing maintenance, you are going to move the scanner or are
directed to turn the power off by Technical Support.
• For the Kodak i5800/i5850 Scanner only: There are four leveling feet
on the bottom of the scanner. If you need to move the scanner, these
leveling feet must be raised. Contact Technical Support before
attempting to relocate the scanner.
• Damages incurred when moving a scanner will not be covered by the
Equipment Service Agreement. Kodak Professional Services provide
relocation services. Go to www.kodakalaris.com/go/dicontacts for more
information.
i5200/i5600
Scanners
i5800/i5850
Scanners
i5200V/i5600V
To Next Page
Loading...
