Kodak i5000 Series - Power Modes

A-61670 August 2014 2-7
Power modes The following chart provides information regarding the power modes of the
scanner, LED status and the manual or automatic action that will put the
scanner into a given power mode.
Mode LED Power
consumption
Manual Action Automatic Action
Scanner off Off 0 watts Turn the power switch on the
back of the scanner to the Off
position (O).
None
Standby Steady yellow < 1 watt This is the mode the scanner
is in when the power is first
turned on (the power switch on
the back of the scanner is in
the On position [I]).
The scanner goes from Low
Power mode to Standby
mode by pressing the Power
button for more than 2
seconds.
Low Power Flashing
yellow
< 4 watts
The scanner goes from Ready
mode to Low Power mode by
pressing the Power button for
more than 2 seconds.
Ready Steady green <115 watts
not scanning
(all models)
< 215 watts
scanning
(i5200/i5600)
<250 watts
scanning
(i5800/i5850)
<350 watts
scanning and lift
operation
(i5800/i5850)
The scanner goes from
Standby mode to Ready
mode by:
• Pressing the Power button,
or
• placing paper in the input
elevator.
The scanner goes from Low
Power mode to Ready mode
by:
• Pressing the Power button,
or
• placing paper in the input
elevator, or
• pressing the Start/Resume
button, or
• receiving a host command.
None