A-61670 August 2014 3-17
Viewing the Operator Log When you touch Operator Log, the Operator Log screen will be displayed.
This screen provides the time, message code and a message description.
The messages that are displayed in the log are only those messages that have
occurred since the scanner was powered on. When you turn the power off or
the scanner goes into Standby or Low Power mode, the Operator Log on the
Operator Control Panel touchscreen will be cleared.
To view messages which have been cleared from the Operator Control Panel
touchscreen, see Chapter 7, Troubleshooting.
• After viewing the operator log, touch Close to return to the Idle screen.
Viewing scanner
information
The Information screen provides information about your scanner (e.g.,
Firmware Version Number, Scanner Serial Number, Total Scanned
Documents, etc.). Use the scroll bar to view all information.
• After viewing this information, touch Close to return to the Idle screen.
Clearing the paper path Touch Clear Path to allow the scanner to eject any documents that are left in
the transport.
Diagnostics Select Diagnostics to run a Print Test, put the scanner in Count Only mode,
perform a UDDS (ultrasonic) calibration, perform a Touchscreen calibration
view the maintenance meters and view the scan history.
To Next Page
Loading...
