Kodak Ngenuity 9090DB - Bbh_Cap_Cam_Brightness

Ngenuity TWAIN Data Source November 19, 2009
Page 68 of 99
Supported Messages:
MSG_GET - TW_ENUMERATION (for 2.0 applications), TW_ONEVALUE (for
<2.0Applications)
MSG_GETCURRENT - TW_ONEVALUE
MSG_GETDEFAULT - TW_ONEVALUE
MSG_RESET – TW_ONEVALUE
MSG_SET – TW_ONEVALUE, TW_ENUMERATION
MSG_QUERYSUPPORT - TW_ONEVALUE
Allowed Values:
FALSE, TRUE
Default Value:
FALSE
Query Support Value:
TWQC_GET |TWQC_GETDEFAULT |TWQC_GETCURRENT | MSG_SET| MSG_RESET
Stored in registry:
Yes
Stored in profile:
Yes
3.8.13 BBH_CAP_CAM_BRIGHTNESS
This is a factory only setting, see implementation notes.
Value to set in the camera for its (input)
brightness control. It can be different on different sides.
Type:
TW_UINT8
Supported Messages:
MSG_GET - TW_RANGE
MSG_GETCURRENT - TW_ONEVALUE
MSG_GETDEFAULT - TW_ONEVALUE
MSG_RESET – TW_ONEVALUE
MSG_SET – TW_ONEVALUE, TW_RANGE
MSG_QUERYSUPPORT - TW_ONEVALUE
Allowed Values:
0 to 255
Default Value:
144
Query Support Value:
TWQC_GET |TWQC_GETDEFAULT |TWQC_GETCURRENT | MSG_SET| MSG_RESET
Stored in registry:
Yes