Kodak Pixpro AZ651 - AP Mode; Station

37
1. Rotate the mode dial to and then enter
the Wi-Fi selection interface.
2. Press the [ ]/[ ] button to select
and set options.
• 「Settings」：
Customize the Wi-Fi settings for the
camera system.
• 「Station」：
Use the Station Mode to connect to
a “Personal Hotspot” created by your
mobile device.
• 「AP Mode」：
In AP mode, the camera will act as an
access point enabling another Wi-Fi
device to connect to it.
Rotate the mode dial to disconnect.
AP Mode
This camera may connect with your smart
device through Wi-Fi.
Settings of Camera:
1. Select and press the button to enter
the setting interface.
2. Press the [ ]/[ ] button to
select options to be adjusted, and press
the button to enter the option setting
interface.
AP mode
Back
Refresh
Setting pre-connected device for the
following serial number:
SSID: PIXPRO AZ651_XXXX
WPA2-PSK: XXXXXXXX
• Refresh: Create a new WPA2 PSK
password.
• Back: Back to previous page.