Kodak RVG - Using a Synchronization Link; Orienting the Image

Acquiring a Good Image
KODAK RVG Digital Radiography Systems User’s Guide (CS4000_en) 2–11
Using a Synchronization Link
If a Kodak generator is linked to the computer using a
synchronization link, you can acquire a new image
without using the F2 button, clicking on the RVG
Acquisition icon, or pressing the sensor remote control
button. The Kodak generator informs the software
that radiation is about to be produced and triggers the
appropriate receptive state in the sensor.When using a
synchronization link, the
RVG Acquisition button is
constantly green.
Orienting the Image
If you press F2 or click the RVG acquisition button,
by default, images are displayed vertically as though
an image of a tooth from the lower dental arch was
acquired.
To orient the image before acquisition, follow these
steps:
1. Press the button on the remote control.
2. Click the button until you reach the configuration
that is most fitting. The image is displayed in the
clinical sense.