Kohler 6VSG Service Manual

TP-6844 1/13 Section 3 Controller 49
3.9 Setting the OnCue Password
If the Kohler OnCue Generator Management System
is used to monitor the generator set, reset the OnCue
password as described below for the VSC.
See Figure 3-22 during this procedure.
1. Press Select and then press the down arrow
button to navigate to the networking Information
menu.
2. Press Select. Networking Status is displayed.
3. Press the Down arrow button. Networking
Configuration is displayed.
4. Press Select. Reset OnCue Password is
displayed.
5. Press and HOLD the Select button until Reset
OnCue Password? No appears. The word No
will flash.
6. Press the Up arrow button to change the word No
to Yes.
7. Press Select to reset the password. The
generator set serial number and new password
are displayed for 10 seconds. Be sure to write
down the new password for entry into the OnCue
program.
Figure 3-22
Figure 3-22 Setting the OnCue Password, VSC
KPS_077
<---- Return
DHCP:
Enabled
Reset OnCue
Password
Reset OnCue
Password? No
S/N: 1234567
New PW: 12345
Press Select to enter YES
or NO as displayed. New
password is displayed for
approximately 10 seconds.
Networking
Configuration
HOLD
Reset OnCue
Password? Yes
UP arrow for YES,
Down arrow for NO.
Networking---->
Information
Networking---->
Status

Kohler 6VSG Specifications

General

Brand	Kohler
Model	6VSG
Category	Portable Generator
Language	English