31
WARNING!
WARNING!
WARNING!
WARNING!
Before Installation And Initial Operation
Safety
Operating the device incorrectly can cause serious injury and damage to property.
▶ Do not use the functions described here until you have fully read and understood the
Operating Instructions.
An electric shock can be fatal.
If the power source is connected to the grid during installation, there is a danger of serious
personal injury and property damage.
▶ Only carry out work on the device when the power source’s power switch is in the -
O - position.
▶ Only carry out work on the device when the power source has been disconnected
from the grid.
Intended use
The power source is intended exclusively for MIG/MAG, MMA, and TIG welding.
Utilization for any other purpose, or in any other manner, shall be deemed to be not in
accordance with the intended purpose.
The manufacturer shall not be held liable for any damages arising from such use.
Intended use also means
- Following all the instructions in these Operating Instructions
- Carrying out all the specified inspection and maintenance work
Setup
regulations
The device has been tested according to degree of protection IP 23. This means:
- Protection against penetration by solid foreign bodies with diameters > 12 mm (0.49
in.)
- Protection against spraywater at any angle up to 60° from the vertical
The device can be set up and operated outdoors in accordance with degree of protection
IP 23.
Direct moisture (e.g., from rain) must be avoided.
Toppling or falling devices can be deadly.
▶ Place devices on a solid, level surface so that they remain stable.
Danger of electrical current due to electrically conductive dust in the device.
This can result in severe personal injury and damage to property.
▶ Only operate the device if an air filter is fitted. The air filter is a very important safety
device for achieving IP 23 protection.
To Next Page
Loading...