34
Connecting the
gas
cylinder
WARNING!
Danger of severe injury and damage to property if gas cylinders fall over.
When using gas cylinders:
▶ Place them on a solid, level surface in such a way that they remain stable
▶ Secure the gas cylinders to prevent them from falling over
▶ Install the VR holder option
▶ Observe the safety rules of the gas cylinder manufacturer
1 Place the gas cylinder on the base of
the trolley
2 Secure the gas cylinder against falling
using the cylinder strap in the upper
area of the gas cylinder (but not on the
neck of the cylinder)
3 Remove the protective cap of the gas
cylinder
4 Briefly open the gas cylinder valve to
remove any dirt
5 Inspect the seal on the gas pressure
regulator
6 Screw the pressure regulator onto the
gas cylinder and tighten it
7 Connect the protective gas shield
hose of the interconnecting hosepack
to the pressure regulator using a gas
hose
NOTE!
US devices are supplied with an adapter for the gas hose:
▶ Seal the outside thread on the gas solenoid valve using suitable means before
screwing on the adapter.
▶ Test the adapter to ensure that it is gas-tight.
To Next Page
Loading...
