M-SS-017-07 Rev C 3 SERVOSTAR CD
SAFETY
Only qualified personnel are permitted to transport, assembly, commission, and maintenance this
equipment. Properly qualified personnel are persons who are familiar with the transport, assembly,
installation, commissioning and operation of motors, and who have the appropriate qualifications for their
jobs. The qualified personnel must know and observe the following standards and regulations:
IEC 364 resp. CENELEC HD 384 or DIN VDE 0100
IEC report 664 or DIN VDE 0110
National regulations for safety and accident prevention or VBG 4
— Read all available documentation before assembly and commissioning. Incorrect handling of products
in this manual can result in injury and damage to persons and machinery. Strictly adhere to the
technical information on the installation requirements.
— It is vital to ensure that all system components are connected to earth ground. Electrical safety is
impossible without a low-resistance earth connection.
— The SERVOSTAR
®
product contains electro-statically sensitive components that can be damaged by
incorrect handling. Discharge yourself before touching the product. Avoid contact with high
insulating materials (artificial fabrics, plastic film, etc.). Place the product on a conductive surface.
— During operation keep all covers and cabinet doors shut. Otherwise, there are deadly hazards that
could possibility cause severe damage to health or the product.
— In operation, depending on the degree of enclosure protectio
n, the product can have bare components
that are live or have hot surfaces. Control and power cables can carry a high voltage even when the
motor is not rotating.
— Never pull out or plug in the product while the system is live. There is a danger of electric arcing and
danger to persons and contacts.
— After powering down the product, wait at least ten minutes before touching live sections of the
equipment or undoing connections (e.g., contacts, screwed connections). Capacitors can store
dangerous voltages for long periods of time after power has been switched off. To be safe, measure
the contact points with a meter before touching.
When the symbols below appear in this manual, be alert to the potential for personal injury and/or damage
to the equipment. Follow the recommended precautions and safe operating practices included with the
alert symbols. Safety notices in this manual provide important information. Read and be familiar with these
instructions before attempting installation, operation, or maintenance. The purpose of this section is to
alert users to possible safety hazards associated with this equipment and the precautions that need to be
taken to reduce the risk of personal injury and damage to the equipment. Failure to observe these
precautions could result in serious bodily injury, damage to the equipment, or operational difficulty.
WARNING
Potential physical danger or harm. Failure to follow warning notices could result in
personal injury or death.
CAUTION
General precautions, which if not followed, could result in personal injury and/or
equipment damage.
NOTE
Information critical to your understanding or use of the product.
To Next Page
Loading...
Need help?
General
