Kongsberg cNODE Micro - Disconnecting Cnode Micro from the ROV; Powering up the TTC; Acoustic Test

426351/A
21
Procedure
1ConnectthecablebetweenthecNODEMicroandtheROV .
2Turnonthepowersupply(24VDC)tothecNODEMicro.
DisconnectingcNODEMicrofromtheROV
ItisveryimportanttoreadtheproceduresbeforedisconnectingthecNODEMicro
fromtheROV .
Prerequisites
Note
Alwaysturnoffthepowersupply(24VDC)beforedisconnectingthecNODEMicro
fromtheROV .
Procedure
1Turnoffthepowersupply(24VDC)tothecNODEMicro.
2DisconnectthecablebetweencNODEMicroandtheROV .
PoweringuptheTTC
Procedure
1PlacetheTTCinasuitablelocation.
2Openthecasebypressingthehandleknobsandpullingthehandlesup.
3Turnonthemainpowerswitchtoloadthesoftware(thistakesapproximately1.5
minutes).
Result
Thesystemisnowreadyforoperation.
Acoustictest
Performtheacoustictesttomakesurethetransponderisfunctioning.
Prerequisites
Pre-deploymentcheckshavebeendone.
Gettingstarted