The monitor image can be made lighter or darker. The
brightness level can be set individually for viewfinder and direct
viewing. Turn the mode switch to the appropriate position. Press
and hold the information (i
+
) button to open the LCD brightness
screen.
Use the left/right keys of the controller to adjust
the brightness; the monitor image changes
accordingly. Press the center of the controller to
set the brightness level or press the menu
button to close the screen without applying any
changes.
28 B
ASIC RECORDING
Pressing the information (i
+
) button changes the monitor display. The display cycles
among the standard display, real-time histogram, and live image only.
Standard display
Information button
i
+
BUTTON
ADJUSTING MONITOR BRIGHTNESS
Set LCD brightness
:adjust
:enter
Low High
The real-time histogram shows the approximate
luminance distribution of the live image. This
histogram cannot show the affect of flash illumination.
The histogram of a recorded image may not show the
same distribution as the real-time histogram.
Real-time histogram Live image only
To Next Page
Loading...
Need help?
General
