86 A
DVANCED PLAYBACK
VIEWING IMAGES ON A TELEVISION
It is possible to view camera images on your television. The camera has a video-out
terminal to make the connection using the supplied AV cable. The camera is compatible
with the NTSC and PAL standards. The video-output setting can be checked and set in
section 4 of the setup menu (p. 98).
1.Turn off the television and the camera.
2.Open the terminal cover and insert the small plug
of the AV cable into the camera’s AV-out terminal.
The arrow on the plug should face the back of the
camera.
3.Plug the other end of the AV cable into the video
and audio input terminals on the television. The
yellow plug is for the video output. The white plug
is for the monaural audio output.
4.Turn the television on.
5.Change the television to the video channel.
6.Turn the camera’s mode dial to the playback
position and turn on the camera. The camera’s
monitors will not activate when the camera is
attached to a television. The playback-mode
display will be visible on the television screen.
7.View images as described in the playback section.
To Next Page
Loading...
Need help?
General
