Konica Minolta REGIUS 110 HQ - 2.3 Removing Protective Parts

2.3 Removing Protective Parts
2-11
2.3 Removing Protective Parts
This machine incorporates protective parts to protect internal components from damage caused by
vibration experienced during transportation. Remove these protective parts (red parts).
Requirements
The procedures described in this manual require the following tools:
2.3.1 Removing External Panels
Remove the external panels to remove the protective parts (red parts) from the machine interior.
1 Remove the first front back panel.
•
Seven screws (M4 × 8)
Hold the bottom of the panel with both hands and pull it
towards you to remove it.
2 Remove the first front panel.
•
Six screws (M4 × 8)
Hold the bottom of the panel with both hands and pull it
towards you to remove it.
This is the final step in the process of removing the external panels.
Protective Parts Quantity
Fixture (red part) Six pieces
No. Tools
1 Phillips head screwdriver
B
ac
k
o
f
t
h
e
fir
st
fr
o
n
t
s
i
de
First front
side
0404YF220A.book 11 ページ ２００９年８月２０日 木曜日 午後１時２６分