3.2 Connecting System
3-5
Work Procedure
Set up the network from the REGIUS console.
• Network settings for the unit: Host name, IP address, host name of the JM, host name of the
REGIUS console to be connected, etc.
• Network settings for the REGIUS console and JM: Host name, IP address, host name of the unit,
etc.
For information about the procedure for setting the network, refer to the REGIUS console Installation/
Service Manual.
This is the final step in the process of setting up the network.
3.2.3 Connecting to Network
Connect the unit to the network.
1 Connect the unit to the system using Ethernet
cables.
(The figure shows the connection of the unit to the
Ethernet connection port.)
Fix the Ethernet cables as required by the conditions at
the installation location.
2 Check the network connection.
After the network connection is completed, turn ON the
REGIUS console and the unit to check that no network
error occurs.
For information about the procedure for making and checking the network connection, refer to the
REGIUS console Installation/Service Manual.
This is the final step in the process of connecting to the network.
Next, set up the REGIUS console. For information about the settings and procedure, refer to the
REGIUS console Installation/Service Manual.
Proceed to “3.3 Checking Operations and Backing Up Setup Data” to checkheck whether the unit
operates in the system to read images successfully.
Back of the second front side
0404YF220A.book 5 ページ ２００９年８月２０日 木曜日 午後１時２６分
To Next Page
Loading...
