Konica Minolta REGIUS 110 HQ - Removing Protective Parts (Back of First Front Side)

2.3 Removing Protective Parts
2-14
2.3.4 Removing Protective Parts (Back of First Front Side)
Remove protective parts D through F on the back of the first front side.
Removing Protective Part D
1 Remove protective part D.
•
Four hexagonal Phillips socket screws (M5 × 10)
Removing Protective Part E
2 Remove protective part E.
•
Four hexagonal Phillips socket screws (M5 × 10)
Removing Protective Part F
3 Remove protective part F.
•
Three hexagonal Phillips socket screws (M5 × 10)
This is the final step in the process of removing the protective parts on the back of the first front side.
Protective part F
Protective part E
Protective part D
Back of the first front side
Caution
Remove the screws while supporting
protective part D so that it will not drop.
Back of the first front side
Back of the first front side
0404YF220A.book 14 ページ ２００９年８月２０日 木曜日 午後１時２６分