KORG D1600 Guided Tour
19
Work with the Counter:
1. Press the STOP key to stop playback, and press the IN/LOC1 key to reset the song to the beginning.
2. Press to highlight “000:00: 000 on the “Counter”, then rotate the DIAL until the “Counter” reads “001:50:000”.
The Counter display type can be set to read in four formats, by pressing the “Clock” icon to the left of the “Counter”, and
selecting a display type from the menu:
Note: In addition to the Counter display, the display can be set to read in Tempo, Mark, or Scene formats, by selecting from the
popup menu below the song name edit cell.
Note: If you’ve just made changes to the “Counter” settings, reset the counter to read in Minutes, Seconds, 1/1000 of second
(realtime) as originally set. Also note that the Counter time location display defaults to Measures, Beats, Ticks when a new
song is created.
Work with the lead guitar track (Track 3):
3. Press the Channel 3 (lead guitar track) TRACK STATUS key so that it lights green (un-muted). Tracks 1, 4, 7, 8, 9 and 10
should also be un-muted (TRACK STATUS keys lit green).
Scrub the audio to find and set a precise locate point:
4. Press the SCRUB key, then press the “>” popup button in the upper-left of the display. Press the “Track 3” radio button.
5. Rotate the DIAL to the right, until you see (and hear) just the lead guitar track’s waveform (beginning at approximately
“001:51:367”). You can press the “ZOOM” buttons to the left of the waveform display, to resize the waveform view, and you can
rotate the DIAL to the right or left to scrub the audio.
6. Rotate the DIAL until the “crosshair” is at the beginning of the waveform (approximately “001:51:367”).
7. Press the STORE key, then press the TO/LOC3. You can use this new locate point whenever you like, to reset to the stored
locate point for this track.
8. Press the SCRUB key once again, to return to the SCRUB page, then try the following functions available in SCRUB mode:
To Next Page
Loading...
Need help?
General
