KORG D1600 Guided Tour
37
The tempo map has been created, and you can view each event by pressing the “Map005” parameter in the upper left of the
display, and rotating the DIAL left or right. You’ll see the measure, tempo and pattern information for each event entered.
Tip: If you like, you can practice playing while the tempo map plays back. To do this, you’ll need to press the “SetUp” tab, then
press “Rhythm:Off” to turn “Rhythm:On”. Press the IN/LOC1 key to reset to the song beginning, then press the PLAY
key. When finished practicing, press the STOP key, then press “Rhythm:On” to turn “Rhythm:Off”.
Record the new Tempo Map to stereo tracks:
The metronome and rhythm pattern playback can be assigned to any inputs and recorded. You can even add EQ and effects to the
recorded rhythm tracks on playback. You can also playback rhythm patterns and tempo maps without recording to tracks, as you
record guitar or other instruments.
11. Make sure that you’ve set “Rhythm:Off”. If on at this point, the sound will be recorded to the tracks in duplicate, and also to the
master L/R bus.
12. Press the INPUT/TUNER key, then press the “Ch1-8” tab.
13. Press the “Ch1” icon and rotate the DIAL to select “L” (the last available setting). The upper left of the display indicates
“RhythmL”.
14. Press the “Ch2” icon and rotate the DIAL to select “R” (the last available setting). The upper left of the display indicates
“RhythmR”.
15. Press the RECORD key, and make sure that “Input” is selected as the record mode.
16. Press the TRACK STATUS keys for Channels 1 and 2 so that they each light red (Record status), then raise the MASTER and
1 / 2 faders to “0”. Set the Pan knobs to L/R to record in stereo.
17. Press the METER/TRACK VIEW key, then press the REC key (REC and PLAY will flash) and you will hear the initial pattern in
the tempo map (looping)…
18. Press the PLAY key, and record the tempo map. After the tempo map has been recorded (32 measures), press the STOP key.
19. Press the PLAY key to playback the recorded Tempo Map.
20. Press the STOP key to stop playback, then press the IN/LOC1 key to locate to the song beginning.
21. Press the Channel 1 and 2 TRACK STATUS keys 2x, until both LED’s light green (Play status).
Record a guitar track as the recorded rhythm track plays back:
1. Press the Channel 8 TRACK STATUS key 1x, until the LED lights red (Record status).
2. Check the METER/TRACK VIEW display and make sure it is set for “PreFdrLevel” view. Play your guitar and adjust the
Channel 8 fader and trim knob so that the input signal does not clip.
3. Press the REC key, then press the PLAY key, and record the guitar track.
4. Press the STOP key when finished, then press the IN/LOC1 key to reset to the song beginning.
5. Press the Channel 8 TRACK STATUS key 2x, (green), then press PLAY to playback the song.
To Next Page
Loading...
Need help?
General
