KORG D1600 Guided Tour
39
Write and finalize a CD:
9. Press the CD-R/CD-RW drive eject button, then insert a blank CD-R disk and press to close the drive bay.
10. Press the SONG key, then press the “CDR/RW” tab.
11. Press the “WriteToCD” button, and a “Copyright” dialog box will appear.
12. Select the write speed (2x or 4x) by pressing the “4x” button, then press the “Yes” button. The writing process will begin, and
when the display indicates “Completed”, press the “Yes” button.
13. Select the next song in the “SongSel” tab, then press the “CDR/RW” tab, and continue from step 3 above. Note: All songs
must be in two track format (tracks 1 and 2) before writing to CD.
14. Once all of the songs are written to CD, press the “Finalize” button, then press the “Yes” button. When the finalizing is
completed, the CD will automatically eject.
Playback the new song from CD:
15. Re-insert the CD in the drive, then press the INPUT/TUNER key, and set input channels 1 and 2 to “CD-L” and “CD-R”.
16. Press the SONG key, then press the “CDR/RW” tab.
17. Press the “Play/Stop” button to playback the CD:
Tip: For more information on CD mastering with the D1600, see the Owner’s Manual, page 49 and 91.
Tips: After you’ve completed this guide, make sure to Delete all of the copied and new songs you created as you went through
each exercise – see the QuickSteps that follow for the procedure. And you may want to backup the demo song to CD
before deleting it from the internal hard disk.
To Next Page
Loading...
Need help?
General
