Korg D1600 - Step 7. Using the mixer; Moving a registered scene to another time location; Scene filtering; Using MIDI to control scenes

KORG D1600 Guided Tour
41
Loop recording:
LOOP key Ô Set Counter location Ô STORE key: set IN point Ô Set Counter location Ô STORE key: set OUT point Ô Set Loop:On Ô AUTO PUNCH key Ô
Press RolTime and set pre-roll and post-roll time Ô Set AutoPunch:On Ô Set TRACK STATUS to RECORD (red) Ô Ô Press REC Ô Press PLAY Ô Auto-punch
recording at IN point and ends at OUT point , then continues to loop Ô STOP Ô Press UNDO key and select best take from list
ÔOM pg. 31
Recording on virtual tracks:
TRACK key Ô Vtr tab Ô Set Virtual track with DIAL Ô Set TRACK STATUS to RECORD (red) Ô Record the track Ô STOP
ÔOM pg. 27
Loop playback:
Set TRACK STATUS to PLAY (green) Ô Set Counter location Ô Set IN point Ô Set Counter location Ô Set OUT point Ô LOOP key Ô Set Loop:On Ô Press
PLAY to start loop playback Ô STOP
Ô OM pg. 33
Setting the Counter display:
SONG key Ô SongSel tab Ô Press the “clock” icon to the left of the Counter Ô Select time display Ô OK
ÔOM pg. 35
Moving to a specific time location with the Counter:
SONG key Ô SelSong tab Ô Press to highlight the Counter position desired Ô Rotate DIAL
ÔOM pg. 35
Storing and moving to Locate points:
Set Counter location Ô STORE key Ô IN/LOC1, 2, 3 or 4 key / To move to a Locate point, press the desired LOCATE key. Note: You can also set and recall Locate
points during playback.
ÔOM pg. 35
Storing and moving to Mark locations:
SONG key Ô SelSong tab Ô Move to Counter location desired Ô STORE key Ô MARK key / To move to a Mark location: MARK key Ô Press Mark number Ô
Rotate DIAL to desired number Ô Press Recall. Note: You can also set and recall Mark points during playback.
ÔOM pg. 36
Storing Scenes:
SONG key Ô Move to Counter location desired Ô Adjust Fader, Pan, EQ and Effects as desired Ô STORE key Ô SCENE key. Note: Scenes can be stored during
playback and recording.
ÔOM pg. 39
Automatically switching Scenes during song playback:
SONG key Ô SCENE key on (red) Ô Move to Counter location desired Ô Press PLAY key
ÔOM pg. 39
Using the Scrub function to find a time location:
SCRUB key Ô Press > to select track Ô OK Ô Rotate DIAL to desired location
ÔOM pg. 36, 101
Using the Scrub function to playback tracks at half-speed:
SCRUB key Ô Press > to select track Ô OK Ô Press FF to playback Ô STOP
ÔOM pg. 101
Setting song tempo with the Tap Tempo method:
TEMPO key Ô Press TmpTrk tab Ô Select MeasTap or BeatTap Ô Press RecStart Ô Tap PLAY key as song plays Ô STOP at 1
st
beat of next measure Ô Press
SetUp tab Ô Press > to select TempoTrk Ô Reset song Ô Press PLAY key
ÔOM pg. 63
Rehearsal mode with Auto-Punch recording:
AUTO PUNCH key Ô Set Counter location Ô STORE key: set IN point Ô Set Counter location Ô STORE key: set OUT point Ô Set TRACK STATUS to RECORD
(red) Ô Press RHSL key Ô Set AutoPunch:On Ô Press REC key Ô Press PLAY key Ô Rehearsal recording will begin Ô When ready to record, press RHSL key
(unlit) Ô Press REC key Ô Press PLAY key Ô Record Ô STOP / Note: can also use with Loop Recording method
ÔOM pg. 112