KORG D1600 Guided Tour
32
16. Press the METER / TRACK VIEW key, then press the PLAY key to playback and view the post fader levels for Tracks 13 and
14.
17. When you're finished playing back the mixdown, press the STOP key, then press the IN / LOC1 key to locate to the song
beginning.
Work with the Clipboard, Fade, and Undo functions:
The following exercises use the current song…
Set an OUT point for the bounced audio tracks:
1. Press the SONG key, then press the “Counter” and use the DIAL to set it to read: “001:12.000”.
2. Press the STORE key, then press the OUT/LOC2 key, to set an OUT point (the IN point is already set to the beginning of the
song).
Copy the selected audio region to the “Clipboard”:
The “Clipboard” allows you to copy selected data from one song to another. The IN and OUT points set in the previous steps indicate
a selected audio range. The TO point needs to be set in the destination song only if you want the audio data in the Clipboard to be
copied to a location other than the beginning of the song.
3. Press the TRACK key, then press the “EditTrk” tab.
4. Press the “>” popup button and press to select the “Copy” radio button, followed by pressing the “OK” button.
5. Press to highlight the “edit cell” “1” in the left area of the display, then rotate the DIAL to read “13-14”.
6. Press to highlight the “edit cell” “1” above the “EditTrk” tab, then rotate the DIAL to read “Clip2”. Note: The edit cell reads
“Clip2” when two or more tracks have been copied, and reads “Clip1” when a single track is copied.
7. Press the “Exec.” button, then press the “Yes” button. Press the “OK” button to copy tracks 13b and 14b to the Clipboard.
Copy the Clipboard contents to a new song:
This is an efficient way to “import” your two track mixdown to a new song, where no effect or EQ processing is assigned to tracks 1
and 2.
8. Press the SONG key, then press the “New” button in the display, followed by pressing the “OK” button.
9. Press the TRACK key, and press to highlight the “edit cell” “1” in the left area of the display, then rotate the DIAL to read
“Clip2”.
10. Press to highlight the “edit cell” “1” above the “EditTrk” tab, then rotate the DIAL to read “1-2”.
11. Press the “Exec.” button, then press the “Yes” button. Press the “OK” button to complete the copy procedure.
12. Press the METER/TRACK VIEW key, then press the PLAY key, and raise the Channel 1 and 2 faders and MASTER fader for
playback, avoiding clipping.
To Next Page
Loading...
Need help?
General
