Korg drumlogue - Page 29

29
SOUND SELECT
LAYER [01..10]
Select the layer sound type of low tom or high tom.
A short PCM sample is layered on the low tom and high tom analog sound sourc-
es, allowing you to change the tone character of the aack.
PARAMETERS
SWEEP [0.0%...100.0%]
Adjusts the level of the sweep (which changes the pitch when triggered) of low
tom or high tom.
ATTACK [0.0%...100.0%]
Adjusts the level of the layered sound of low tom or high tom.
CUTOFF [L0.0%...L99.5%, THRU, H0.5%...H100.0%]
Sets the cuto frequency of the lter of low tom or high tom.
You can select the low-pass lter, no lter (THRU), or the high-pass lter.
RESON (CUTOFF RESONANCE) [0.0%...100.0%]
Sets the cuto resonance of the lter of low tom or high tom.
If you increase the value, the lter oscillates, which may cause the sound to
continue.
DRIVE [OFF, LOW, HIGH]
Sets the distortion amount of low tom or high tom. A fat sound is created by mod-
erately distorting low tom or high tom.
MIX/ROUTE
PAN [L100%...L1%, C, R1%...R100%]
Adjusts the pan pot (left and right stereo localization).
DELAY [0.0%...100.0%]
Adjusts the feed amount of the delay eect.
REVERB [0.0%...100.0%]
Adjusts the feed amount of the reverb eect.
MASTER [ON, BYPASS]
Sets the master eect to On or Bypass.
SIDECH (SIDECHAIN) [0.0%...100.0%]
Adjusts the feed amount of the SIDECHAIN pass.