Korg drumlogue - Analog Sound Source: Toms (LT, HT)

28
SNAP.LV (SNAPPY LEVEL) [0.0%...100.0%]
Adjusts the snappy volume of the snare drum.
CUTOFF [L0.0%...L99.5%, THRU, H0.5%...H100.0%]
Adjusts the cuto frequency of the lter.
You can select the low-pass lter, no lter (THRU), or the high-pass lter.
RESON (CUTOFF RESONANCE) [0.0%...100.0%]
Adjusts the cuto resonance of the lter.
If you increase the value, the lter oscillates, which may cause the sound to
continue.
MIX/ROUTE
PAN [L100%...L1%, C, R1%...R100%]
Adjusts the pan pot (left and right stereo localization).
SPREAD [<100%...<1%, 0, >1%...>100%]
Adjusts the spread of sound (stereo feeling).
DELAY [0.0%...100.0%]
Adjusts the feed amount of the delay eect.
REVERB [0.0%...100.0%]
Adjusts the feed amount of the reverb eect.
MASTER [ON, BYPASS]
Sets the master eect to On or Bypass.
SIDECH (SIDECHAIN) [0.0%...100.0%]
Adjusts the feed amount of the SIDECHAIN pass.
LT, HT (Low tom, High tom)
Control knob
LT (HT) DECAY [0...1023]
Adjusts the sounding length of the low-tom or high-tom drumhead.
The greater the value, the longer the sound.
LT (HT) TUNE [0...1023]
Adjusts the pitch of the low tom or high tom. The greater the value, the higher the sound.
LT (HT) DETUNE [0...1023]
Adjusts the tuning deviation between the two drumheads for low tom or high tom.