Korg drumlogue - Multi-Sound Source: NOISE

35
NOISE
SOUND SELECT
ALGO [LPF 2, LPF 4, BPF 2, BPF 4, HPF 2, HPF 4, DECIM]
Select the noise sound type. The low pass (LPF), band pass (BPF), and high pass
(HPF) provide two types of lters: -12dB/oct and -24dB/oct.
DECIM is the noise source that uses sampling rate decimation.
PARAMETERS
COLOR [0.0%...100.0%]
Adjusts the darkness and brightness of the tone. The lower the parameter value,
the darker the tone.
PEAK (other than DECIM) [0.0%...100.0%]
Adjusts the peak of the lter.
ATTACK [0.0%...100.0%]
Sets the aack time. The higher the value, the slower the rises of the sound.
RELEASE [0.0%...100.0%]
Sets the release time. The higher the value, the longer the sound.
MIX/ROUTE
PAN [L100%...L1%, C, R1%...R100%]
Adjusts the pan pot (left and right stereo localization).
SPREAD [<100%...<1%, 0, >1%...>100%]
Adjusts the spread of sound (stereo feeling).
DELAY [0.0%...100.0%]
Adjusts the feed amount of the delay eect.
REVERB [0.0%...100.0%]
Adjusts the feed amount of the reverb eect.
MASTER [ON, BYPASS]
Sets the master eect to On or Bypass.
SIDECH (SIDECHAIN) [0.0%...100.0%]
Adjusts the feed amount of the SIDECHAIN pass.