36
USER
SOUND SELECT
SELECT [---, Nano, ...]
Select the user synth to load.
At the time of shipment from the factory, the user synth "Nano" developed in col-
laboration with Sinevibes is installed on this unit.
TIP
Parameters vary depending on the user synth. For explanations about
functions other than nano, refer to the manual for each user synth.
PARAMETERS * For Nano
NOTE [C-1...C5]
Sets the sound pitch.
WAVE [2x Saw, 2x Sqr, 2x Tri, Saw+Sqr, Saw+Tri, Sqr+Tri, Ring 1..3]
Select the waveforms of two oscillators.
DETUNE [-24.0...+24.0]
Adjusts the pitch shift between the main oscillator and the sub oscillator.
BALANCE [0%...100%]
Adjusts the volume balance between the two oscillators.
FILTER [LP, HP, BP]
Select the lter type. There are three types of lters: low pass, high pass, and band pass.
CUTOFF [0%...100%]
Adjusts the cuto frequency of the lter.
KEYTRACK [0%...100%]
Adjusts the key tracking eect on the lter cuto.
RESON (RESONANCE) [0%...100%]
Adjusts the cuto resonance of the lter.
EG TYPE [D, A1D, A2D]
Select the type of EG (Envelope Generator).
D: Type with the xed aack and adjustable decay only
A1D: Adjusts the aack and decay at the same time. The aack time and decay
time are the same.
A2D: Adjusts the aack and decay at the same time. The decay time is twice the
length of the aack time.
To Next Page
Loading...
