Korg drumlogue - Page 39

39
You can select the low-pass lter or the high-pass lter.
CUTOFF [0.0%...100.0%]
Sets the cuto frequency of the lter.
SAT. (SATURATION) [0.0%...100.0%]
Sets the saturation level of the lter.
ROUTE [NORMAL, CROSSED, P-PONG]
Sets the feedback signal route.
L
R
NORMAL
L
R
CROSSED
FB
FB
FB
FB
L
R
P-PONG
FB
PARAMETERS - For Mono/Mono BPM
TIME [0.0%...100.0%]/[1/64, 1/48, ... 3/4, 1]
Adjusts the delay time.
* For Mono BPM, set TIME as the relative value for the BPM value of the tempo.
FB (FEEDBACK) [0.0%...100.0%]
Adjusts the delay feedback amount.
FILTER [---, LP, HP]
Select the lter type for feedback.
You can select the low-pass lter or the high-pass lter.
CUTOFF [0.0%...100.0%]
Sets the cuto frequency of the lter.
SAT. (SATURATION) [0.0%...100.0%]
Sets the saturation level of the lter.
PARAMETERS - For Tape/Tape BPM
TIME [0.0%...100.0%]/[1/64, 1/48, ... 3/4, 1]
Adjusts the delay time.
* For Tape BPM, set TIME as the relative value for the BPM value of the tempo.
FB (FEEDBACK) [0.0%...100.0%]
Adjusts the delay feedback amount.
MOD (MODULATION) [0%...100%]
Adjusts the amount of the modulation applied to the delay time period.